Last Modified: 11-29-2007 1.6 A
Service Category: Steering Section: Steering Column
Model Year: 2008 Model: Sequoia Doc ID: RM000002ZV5003X
Title: STEERING COLUMN: STEERING WHEEL: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL STEERING WHEEL PAD ATTACHING SCREW

(a) Install the 2 steering wheel pad attaching screws.

2. INSTALL CRUISE CONTROL MAIN SWITCH

(a) Install the cruise control main switch with the 2 screws.

3. INSTALL STEERING PAD COVER RH (w/o Steering Pad Switch)

(a) Engage the 2 pins to install the steering pad cover RH with the screw.

4. INSTALL STEERING PAD COVER LH (w/o Steering Pad Switch)

(a) Engage the 2 pins to install the steering pad cover RH with the screw.

5. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)



(a) Engage the 4 pins to install the switch with the 2 screws.

(b) Connect the connector.

6. ADJUST SPIRAL CABLE SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION (2008 Sequoia)+

7. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the matchmarks on the steering wheel and steering main shaft.

(b) Install the steering wheel set nut.

Torque: 50 N·m (510 kgf·cm, 37 ft·lbf)

8. INSTALL LOWER NO. 3 STEERING WHEEL COVER SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 Sequoia)+

9. INSTALL LOWER NO. 2 STEERING WHEEL COVER SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 Sequoia)+

10. INSTALL STEERING PAD SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION (2008 Sequoia)+

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .

12. INSPECT STEERING PAD

13. INSPECT SRS WARNING LIGHT

SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: DIAGNOSIS SYSTEM (2008 Sequoia)